Hose whipping accidents 

Are one of the most common accidents associated with operating a concrete pump. With higher horsepower and pump pressures available in today’s pumping equipment, air can momentarily be trapped, compressed, and then released in the delivery system, causing hose whippings. Air can be introduced into the delivery system by various means: 

• When the pump is started initially 

• When restarting the pump after a move which allows the concrete level to fall below the valve 

• When removing a blockage or allowing concrete to free fall after the pump is shut off 

To Avoid Hose Whipping Injury 

• All personnel should remain a prudent and reasonable distance from the end of the delivery line until air is exhausted from the system and concrete is free flowing. 

• If 10 feet of rubber hose is attached to a pipeline, personnel standing more than 10 feet away from the point of attachment are considered outside of the end-hose movement area. 

• Debris coming from the hose during release of trapped compressed air also can be a hazard, so personnel should always wear protection equipment such as a hard hat and eye protection. 

• Do not allow air to be compressed. Compressed air creates stored energy and creates a hazard. 

• When every person on the job understands what can occur when air is compressed in the hose and the proper precautions are made, a successful and profitable concrete pour results 

IMPORTANT NOTE: Do not forget to look for overhead lines before pumping concrete. 

Download the full Toolbox Talk document on Concrete Pumping below:

Download

Source